The SXT Series Handguards feature a free-floating AR-15 handguard with an M-LOK attachment system. The simple clamping system uses two cross bolts which fit into the barrel nut for a rapid and easy installation. (The old SXS Series clamping system used a bias block on the bottom to secure the forearm to the barrel nut which required knurling). Specifications for Samson SXT AR-15 M-LOK Handguard: Manufacturer: Samson Color: Black Finish: MIL-A-8625 type III class 2 anodizing Fabric/Material: 6061-T6 Aluminum Gun Make: AR Platform Gun Model: AR-15 Gun Type: Rifle Handguard Type: Free-Float Gun Rail: Picatinny Condition: New Included Accessories: Standard Inner Diameter: 1.25 in Outer Diameter: 1.6 in Mount Type: M-LOK Quantity: 1 Package Contents: Samson SXT AR-15 M-LOK Handguard Hex wrench Barrel nut Barrel nut wrench
6 reviews for Samson SXT AR-15 M-LOK Handguard
Only logged in customers who have purchased this product may leave a review.
Kavz –
I Wanted To Customize My M4, Obviously Did My Research(Not Enough) And Had Trouble Finding A Handguard That Would Fit,Luckily Samson To Save The Day, The SXT Is Very Inexpensive And Slips Right Over The Factory Nut! And Shipping Was Fast !
rasandequis –
This is well-built, super easy to install handguard. Had it installed into my m400 thread, and I could do it all by myself in 10 minutes. The installation video available on youtube and the manual don't bring much, and you need to do some limited troubleshooting yourself, however, nothing crazy, no mods, just figuring out the steps.
rasandequis –
Nice handguard, well-finished, easy to install. If you ever installed a handguard before, you will have zero problems out of the box with this one, however, if you did not, you may end up having some difficulty, especially around the barrel nut, that comes pre-screwed to the handguard. You likely just need to unscrew the nut from the handguard, install it on the barrel (if you don't have a compatible nut already installed on the barrel already), and then you install the handguard. Just saying because this info is not on the manual and not on the video from Samson.
Andrew –
Excellent fit for my Sig Tread400 AR15. No need to switch barrel nuts, just had to remove old hand guard. At range very solid. Great MLOK cuts.
Phinesse –
Was able to easily swap this handguard onto the Sig M400 since the Barrel Nuts are the same. Only thing was the Samson Handguard had the Barrel nut pre-installed in the Handguard. There was a small hex screw on the bottom side of the Handguard to get the Barrel Nut to come off
TBGunner24 –
The Samson SXT AR-15 M-LOK 15” Handguard looks great as a replacement for the stock 13” that came on my M400 Tread. It came with the same barrel nut as the stock handguard. So, no need to remove the factory installed barrel nut (or the gas block!) from the rifle; just needed a 5/16” hex key to remove the set screw that held the barrel nut onto the Samson SXT – and then remove the barrel nut that shipped installed on it. Once that was removed, the handguard slipped right on, over the gas block, and only two hex screws need to be tightened to install it. SUPER EASY! Just don’t over-tighten the hex screws. Snug each one with “light-moderate” tension, going back and forth between the two, until you can feel them “seat” (bottom out). That’s it! Would definitely recommend this if you prefer a full Picatinny rail.